FLY meter


Measurement device - Fly Henry is designed for three cycles, quad bikes and ULL, basically anywhere where the engine is far from the dashboard. The device is designed in a way which does not require long wiring of all the sensors.

The device consists of 2 modules:
Measurement module: it is placed close to the engine where all sensors connect to it.
Visualization module: it is placed right in front of the pilot’s visual field.
Data cable with an arbitrary length connects these 2 modules.


- 4x temperature measurement in range 0-1000°C - CHT or EGT. Possibility to view the temperature in degrees of Celsius or Fahrenheit

- 1x temperature measurement in range 0-300°C for oil, water, etc.

- 1x oil pressure measurement in a range 0-10 Bar

- Revolution meter

- 4x moto hours

- Setup of the service interval

- Fuel gauge - fuel level in the tank

- Fuel consumption- immediate and average fuel consumption, amount of consumed fuel - Liters or gallons

- Measurement of the onboard voltage

- Alarms: overheating, oil and fuel under pressure, fuel level, onboard voltage drop

- Brightness and contrast of the display regulation


Input Voltage: 7-20V

Visualization module

Dimensions of the front panel: 98 x 64 mm

Dimensions of the aperture in the panel: 93 x 59 mm

Weight: 150g

Measurement module

Base dimensions: 124 x 40 x 20 mm

Weight: 100g


Sensors for FLY meter

FLY Meter Introduction

Shortening of the fuel gauge



FLY meter manual

FLY meter connection


FLY meter - 5.500 CZK VAT excl.

Note: CHT sensor of the length of 80 cm and connection wiring with standard length of 2.8 meters is included in the package.